What and how to properly wash the laminate, so that there are no stains and scratches

The long service life of the laminate board will ensure the right choice of building material when buying and gentle care for it.

Detergents

Lots of laminate cleaners are on sale. These are powders, shampoos, gels, before use, test their effect on an inconspicuous area of ​​the floor. If there are no traces left and the coating is not damaged, then feel free to use the selected version of household chemicals.

purityis.decorexpro.com/en/ recommends when choosing a product to pay attention to its safety, and not just to the effectiveness and quality of removing contaminants. The gel or shampoo should not release toxic substances or cause burns.

Popular means for washing the laminate:

1. Emsal laminate (Emsal Laminate) is a luxury detergent. This is a soap based liquid. It does not leave stains, therefore it is suitable for washing parquet or tile. The main advantage is profitability, since one capacity is enough for three to four months of systematic use. When washing, “Emsal Laminate” provides impregnation of the surface of the floor covering, resulting in shine and reliable protection against dust and moisture.
2. Proper (Mr. Proper) - a budget tool for washing the laminate. Effectively removes dust, dirt and stains, has a very pleasant smell, providing a feeling of freshness in the room after cleaning.
3. Melliured Bio effectively removes any dirt from the laminate even after repair. The specific composition provides smoothing of scales and the formation of a film with water-repellent properties.
4. Bugs Laminate - Thanks to the linseed oil contained in it, it excellently polishes the surface and it acquires a glossy shine. Leaves no stains.

Add ethyl alcohol, lemon juice or table vinegar (2-3 tablespoons to 10 liters of water) to help remove stains, stains, and dirt.

To ensure the shine of the floor and at the same time wash dried dirt, stains, stains will be possible with the help of dishwashing gel. You need to add a little funds to the water and wash the resulting laminate solution.

The appearance of stains is due to the alkali contained in the water, which, when mixed with detergents, leaves whitish streaks. The addition of 550 ml of vinegar to 2.5 liters of water will help prevent the occurrence of stains.

Laminate Washing Instructions

Instruction:

1. Sweep with a broom or broom to remove large debris.
2. Vacuum the surface with a nozzle that does not scratch the coating. Most dust accumulates in the corners, so they should be cleaned especially carefully.
3. Mix the detergent with water according to the instructions on the packaging.
4. Dip the automatic mop into the solution for 3 minutes, wring out the sponge and wipe a small area. Then rinse the sponge, wring it out and continue to the next section.
5. If the solution becomes dirty, pour it out and make a new one.
6. Sometimes to achieve a result, you need to wash the floor again.

At home, washing is better with open windows, this will ensure the drying of the surface as soon as possible, and prevent the formation of wet spots and puddles. If they did appear, then remove excess water with a lint-free dry cloth. After wet cleaning, do not close the windows immediately.

Laminate basically contains fiberboard, not a solid tree.The layers of each plate are bonded together with a special glue that is resistant to physical stress, temperature changes and moisture. However, this is a fairly sensitive coating, it does not like the abundance of water. It is recommended that you wipe the laminate floor once every 1-3 days with a damp microfiber cloth and wash only once a week.

To care for the laminate, a special microfibre mop is best suited. For more gentle cleaning, such tools have a special adjustment lever.

You can not wash the laminate with fleecy rags or old T-shirts, especially colored ones: after this treatment, the coating will become dull. To avoid traces (scratches) on the laminate, discard hard sponges and rags with buttons, seams or embroidery.

How to remove stains

Contaminants that appear on the surface of the laminate are easily cleaned with a window cleaner or ordinary dishwashing gel. Aggressive and especially abrasive products should not be used if you want to keep the floor intact and beautiful.

Common spots and means of removing them:

1. Traces of the felt-tip pen can be removed with a cloth dampened in white spirit.
2. Stains from wine and other alcoholic beverages are easily removed with ethyl alcohol.
3. Fat is removed with ordinary soap. Rub the contamination with a wet, soapy rag and it will disappear.
4. Traces of the rubber sole of the shoe are removed with a pencil eraser. Rub them stains and they will disappear. You can sprinkle contaminated areas with soda and then wipe with a damp rag, but you must be extremely careful not to scratch the laminate. It’s also not worth pushing with an eraser.

Minor scratches appear over time. To make them invisible, they are rubbed with plasticine of a suitable color for the coating or simply painted over with a felt-tip pen.

How to wash the laminate after repair

No matter what the repair was, traces of building materials on the laminate will remain in any case. For cleaning to be fast, efficient and of high quality, you should adhere to the rules:

1. Chalk and plaster carefully, but without pressing, notice with a broom or remove microfiber with a dry cloth. If you immediately start washing, there will remain streaks and stains that will not go away until the end and after the third wash.
2. If there are stains from the mounting foam and paint, then acetone or ethyl alcohol will help to remove them. It is necessary to process a surface quickly and accurately. Apply to the contaminated area and wait approximately 60 seconds. After that, remove the residue with a soft and damp, lint-free cloth.
3. Small scratches are perfectly masked by a wax pencil.
4. Only by removing all stains and removing all debris and chalk can you begin wet cleaning.

Than you can not wash the laminate

There are tools that are strictly forbidden to use when removing contaminants from the laminate. Their impact will cause deformation or at least worsen the appearance of the floor covering.

Do not wash the laminate with the following means:

1. Ammonia is able to corrode the upper protective layer of the laminate board. For this reason, any means containing a similar component cannot be used.
2. Abrasive substances wash and scratch the laminating coating, so they should not be used to remove stains and remove dirt. For the same reason, before washing the floor, it is necessary to remove crumbs, small pebbles and sand from it.
3. Liquids containing chlorine and therefore possessing disinfecting properties destroy the laminate.
4. Tools containing alkali and acid corrode the protective layer of the coating and make the floor matte.
5. To rub the laminate with other types of floor polishing means spoiling it. Silicone, parquet mastic will lead to deformation of the surface layer.
6. You cannot use a steam cleaner when washing, as steam penetrates between the joints and destroys their integrity, as a result of which the floor covering swells and deforms.

It is not recommended to wash the laminate with a washing vacuum cleaner.This is due to the fact that such a coating is very sensitive to excess moisture, and the device sprays water in large quantities. More modern and improved models of washing vacuum cleaners spray moisture in a smaller volume and have nozzles with increased suction power, as well as a special brush that provides removal of moisture residues.

Extend laminate life

Laminate board as a floor covering looks very nice, in operation such a floor is very convenient. In addition, caring for him is not as difficult as it might seem at first glance.

The main means of laminate care are clean water and a soft cloth, you should not wash this floor more than twice a week, you can wipe it with a wet cloth every other day. Daily maintenance is usually not required, as the top layer of material is able to repel dust. The use of a minimum amount of a product specifically designed to care for such a coating will ensure its impeccable cleanliness and delightful gloss.

Recommendations for the operation and maintenance of the laminate:

1. To avoid the appearance of scuffs and scratches, felt stickers on the legs of furniture will help, you can put ordinary cardboard. To avoid scratches, do not walk on the laminate on sharp stilettos.
2. In areas of the floor that are exposed to particularly heavy loads (near the bed, sofa, door), it is better to put mats. This will ensure more uniform wear of the entire coating.
3. Do not drop heavy objects onto the laminate; such a floor must be protected from dirt and sand.
4. If liquid is spilled on the coating, it should be immediately removed with a soft cloth.
5. Floor flowerpots with flowers must be put on special pallets.
6. Laminate discolors when exposed to direct sunlight. To prevent this from happening, shade the windows with blinds or curtains.
7. Wash the coating should be 1-2 times a week, using a special tool - twice a month.
8. After wet cleaning, it is recommended to wipe the laminate with a dry, lint-free cloth.
9. The matte laminate should be wiped daily with a soft cloth.
10. It is not necessary to put mastic on such a floor covering, as it will leave stains on the laminate.
11. To avoid traces of bare feet on a glossy surface, you should walk on this floor in soft slippers.

Useful Tips

Practical tips will help ensure proper care of the laminate, which will significantly increase its life:

1. Do not buy or use linoleum or tile products for laminate flooring. On the composition vial should be marked "for laminate".
2. The appearance of stains will prevent a microfiber cloth. it is necessary to wipe the floor after washing.
3. Before preparing a washing aqueous solution, you should carefully study the instructions for use. The volume indicated by the manufacturer cannot be increased, otherwise the whitish traces cannot be avoided.